Specifications

Chapter 13: Solo and Monitor Busses 135
Configuring the Oscillator and Setting Level
The Oscillator is configured on-screen, and can be activating
on-screen or from the Global Control encoders.
To configure the Oscillator:
1 Go to Options > Misc.
2 As a precaution, click and drag the on-screen Level encoder in
the
Oscillator section to set the Oscillator level to off before
you go any further.
3 Click the Signal pop-up and select from the following signal
types:
•100Hz Sine
• 1 kHz Sine
•10kHz Sine
• Variable Sine
•Pink Noise
• White Noise
4 If you select Variable Sine, you can set the sine wave fre-
quency with the on-screen frequency control (directly to the
right of the
Signal pop-up).
5 Click the on-screen In button to activate the Oscillator.
6 Slowly drag the on-screen Level encoder to set the Oscillator
level.
To activate and set the level for the Oscillator from the Global
Control encoders:
1 Press the Monitoring Global Control encoder to assign Oscil-
lator controls to the Global Control encoder.
2 Under the Global Control display showing Oscillator, press the
corresponding encoder
In switch to turn activate the Oscillator.
3 Rotate the corresponding encoder to set the Oscillator level.
Using Talkback
You can route a single Console or Engine analog input directly
into any output bus using the Talkback circuit. This allows you to
send talkback to outputs (such as Auxes feeding stage monitors)
without having to use a system channel.
Routing Talkback to Output Busses
To route Talkback to an output bus:
1 Go to Options > Misc.
2 In the Talkback section, click the Input Fed to Monitors and
Masters
pop-up and select a hardware input source.
3 Click Route. The switch lights to indicate Route to Selected
mode.
4 Go to the Outputs page and click one or more output fader
strips. The selected fader strips flash.
5 In the confirmation dialog that appears, click Route to confirm
your assignment or click
Cancel to cancel without changing
the current routing.
Activating Talkback Input and Setting Level
Talkback can be adjusted on-screen or from the Global Control
encoders.
To activate and set the level for Talkback input on-screen:
1 Go to Options > Misc.
2 Click the on-screen In button in the Talkback section to acti-
vate the Talkback input.
3 Drag the on-screen Level knob to set the Talkback level.
Oscillator controls in the Options > Misc page
Choosing a Talkback input
Signals are routed to output busses post-mute and post fader.
You can designate a footswitch, Function switch or other trig-
gers to control Talkback. For more information, see
Chapter 21, “Events.”