Specifications

S3L System Guide118
Clearing Matrix Mixer Settings
You can clear mixer input assignments to quickly set all the input
sources to None.
To clear Matrix input assignments:
1 Select one or more Matrix mixers you want to clear.
2 Click the pop-up menu at the bottom of the mixer area and
choose
Clear Mix Sources.
Copying Matrix Mixer Input Settings
You can copy mixer settings from one Matrix mixer to another
mixer of the same type. This lets you quickly duplicate monitor
mixes or other signal feeds.
To copy settings between mixers:
1 Select the Matrix mixer that you want to be the destination of
the copied settings so that it is displayed on-screen.
2 Click the pop-up menu at the bottom of the mixer area and
choose
Replace With Mix and Mix Sources From.
3 Choose the Mtx (Matrix mixer) from the sub-menu whose set-
tings you want to copy to the current mixer.
Delay Compensation with Matrix Mixers
VENUE automatically compensates for the delay offsets that can
arise when combining different signal paths within a Matrix
mixer.
Additional Information about Delay Compensation
• The overall latency through a Matrix is determined by the
path with the highest latency.
• All inputs within a Matrix mix are guaranteed to be phase
accurate, but mixes are not necessarily aligned to each
other. This ensures that all mixes are not penalized in the
case of one or more exceptionally high-latency signal paths.
• Delay compensation only accounts for a channel’s post-in-
sert pickoff. Channels that feed User Inputs and Auxes
(pre-insert) will not be fully compensated for.
Adjusting Matrix Mixer Output
Controls
Matrix Mixer outputs can be controlled using the Global Control
encoders, or on-screen.
Matrix Mixer Output Levels
To control mixer output levels from the Global Control encoders:
1 Make sure the Global Control main menu is displayed in the
Global Control encoder displays.
2 Press the encoder below the display showing Matrixes. Matrix
output 1–8 are assigned to the eight Global Control encoders.
3 Rotate the corresponding encoder to adjust the output level for
the Matrix mixer.
Matrix Mixer Select
Matrix Mixers can be targeted for processing in Channel Control
or on-screen. Processing applies to all linked Main busses.
To target a Matrix Mixer for processing:
1 Assign Matrixes to Global Control.
2 Press the Global Control encoder Sel switch under the display
showing the Matrix output you want to adjust.
Matrix Mixer Output Mute
To control the mute status of a Matrix Mixer from Global Control:
1 Assign Matrixes to the Global Control encoders.
2 Press the Global Control encoder In switch for the Matrix you
want to mute/unmute.
• The
In switch LED is lit when the bus is unmuted.
• The
In switch LED is unlit when the bus is muted.
Copying mixer settings overwrites all the settings on the des-
tination mixer.
To use the built-in Comp/Lim and EQ processors on Ma-
trixes, see “Using Built-In Comp/Lim and EQ on Outputs”
on page 90.
Matrixes Global Control encoder
For more information on Mute operation, see Chapter 14,
“Muting and Mute Groups.”
In
Sel
In
Sel
In
Sel
In
Sel
VCAs
Monitors
MatrixesAux/Grp
In
Sel
In
Sel
In
Sel
In
Sel