Specifications

S3L System Guide112
Aux/Variable Group Output Mute
Aux and Variable Group busses can be muted from the channel
strips and the Global Control encoders.
To control the mute status of an Aux/Variable Group bus from the
channel strips:
1 Bank the desired Aux/Variable Group busses to the channel
strips.
2 Press the Mute switch on the channel strip for the bus you want
to mute. The switch lights solid to indicate the bus is explicitly
muted.
To control the mute status of an Aux /Variable Group bus from the
Global Control encoders:
1 Assign the Aux or Variable Groups you want to control to the
Global Control encoders.
2 Press the In switch next to the Global Control encoder for the
Aux/Variable Group you want to mute/unmute.
• The
In switch LED is lit green when the Group is unmuted.
• The
In switch LED is unlit when the Group is muted.
Aux/Variable Group Output Polarity Invert
(Phase Reverse)
The polarity of any Aux and Variable Group output bus signal
can be inverted (Phase Reverse) from Channel Control. With
linked busses, polarity invert applies to both channels.
To invert the polarity of an Aux/Variable Group bus from a
channel strip:
1 Bank the desired Aux/Variable Group busses to the channel
strips.
2 Press the channel Sel switch for the bus you want to control.
3 Make sure the main Channel Control menu is shown in the
Channel Control displays.
4 Press the Channel Control encoder under the display showing
Input.
5 Press the Page > Channel Control Navigation switch to access
the second page of Input parameters.
6 Under the display showing Phase Reverse. press the encoder
In switch to toggle polarity in/out. The switch LED lights
green when the channel’s polarity is inverted (Phase Reverse is
enabled).
Aux/Variable Group Output Delay
A variable delay (from 0 to 500 ms) can be applied to Aux and
Variable Group busses from Channel Control. With linked bus-
ses, delay is applied to both channels.
To apply delay to a bus:
1 Bank the desired Aux/Variable Group busses to the channel
strips.
2 Press the channel Sel switch for the bus you want to control.
3 Make sure the main Channel Control menu is shown in the
Channel Control displays.
4 Press the Channel Control encoder under the display showing
Input.
5 Under the display showing Delay, rotate the encoder to set the
desired amount of channel delay.
6 Press the corresponding encoder In switch to toggle channel
delay in/out. The switch LED lights green when channel delay
is on (enabled).
For more information on muting and Mute Groups, see
Chapter 14, “Muting and Mute Groups.”