Specifications

S3L System Guide102
To adjust Group output levels from the Global Control encoders
1 Make sure the Global Control menu is shown in the Global
Control displays.
2 Press the Aux/Grp Global Control encoder. Aux outputs 1–8
are assigned to the Global Control encoders.
3 Press the Page > Global Control Navigation switch until the
Group outputs appear in the Global Control displays.
4 Adjust the Global Control encoder under the display showing
the Group you want to adjust. The level indicator in the display
shows the relative fader level setting for that Group.
Group Output Solo
To control the solo status of a Group bus:
1 Bank the Groups to the channel strips by pressing Bank switch
F.
2 Press the Solo switch on the channel strip for the Group you
want to solo. The switch lights solid to indicate the channel is
explicitly soloed.
Group Output Mute
To control the mute status of a Group output from the channel
strips:
1 Press Bank switch F to bank Groups to the channel strips.
2 Press the Mute switch on the channel strip for the Group you
want to mute.
To control the mute status of a Group output from Global Control:
1 Assign the Group you want to control to Global Control.
2 Press the In switch next to the Global Control encoder for the
Group you want to mute/unmute.
• The
In switch LED is lit green when the Group is unmuted.
• The
In switch LED is unlit when the Group is muted.
Group Bus Output Pan
Group bus output pan can be controlled from the channel encod-
ers. When pan is assigned to the encoders, the encoders adjust pan
(for mono Groups) or stereo balance and width (for stereo
Groups) of the Group output to the Main busses only. The Group
outputs in the Patchbay are distinct left and right channels.
Groups-to-Mains assignment is shown in each channel display
when Groups are banked to the channel strips. When the channel
encoder is adjusted, pan/balance/width values are shown in the
display.
To control mono Group output pan:
1 Bank Groups to the channel strips.
2 Press the Pan Channel Encoder Assign switch to assign con-
trol of Group pan to the channel encoders.
3 Turn a channel encoder to adjust the pan for the corresponding
mono Group.
To control stereo Group output balance and width:
1 Press Bank switch F to bank Groups to the channel strips.
2 Press the Pan Channel Encoder Assign switch to assign con-
trol of Group balance to the channel encoders.
3 Press a channel encoder Sel switch to assign Group width con-
trol to that channel encoder.
4 Rotate an encoder to adjust the width for the corresponding
stereo Group.
Press the Back/Top Global Control Navigation switch to re-
turn to the Global Control main menu.
Aux/Grp Global Control encoder
Groups assigned to the Global Control encoders
You can set Output banking to follow AFL selection, and vice
versa. For more information on Solo bus operation, see
Chapter 13, “Solo and Monitor Busses.”
In
Sel
In
Sel
In
Sel
In
Sel
VCMatrixesAux/Grp
In
Sel
In
Sel
In
Sel
In
Sel
Grp 1
Master
Grp 2
Master
Grp 3
Master