User guide

Chapter 5: EuControl 31
Display Track Numbers on Surface
Lets Artist Series units show track numbers as assigned by the current workstation (if supported).
Solo Mode
Lets you configure Artist Series units for the following Solo modes as (if) available in the current workstation:
• Solo-in-Place
• After-Fader Listen (AFL)
• Pre-Fader Listen (PFL)
See the documentation for your specific workstation for details on Solo modes.
Wheel Sensitivity Sliders
(Artist Transport and Artist Control Only)
The sensitivity of the Jog Wheel and Shuttle Ring can be precisely adjusted using the Wheel Sensitivity sliders. The top two sliders
pertain to the Artist Transport, the bottom is the Jog Wheel for the Artist Control.
The center position is the default for each control. Click and drag a slider to move it right for faster response or left for a slower,
more controlled movement. Click the
Reset button to restore the center position.
The name of the currently focussed application is shown above the sliders (the application that will be affected by adjusting Wheel
Sensitivity). If the controls have been locked to a specific application, the display will list it and identify it as the application being
adjusted.
Global or Application Specific
Click to enable the Global option to maintain a single set of your Wheel Sensitivity settings to be available regardless of the current
application.
Click to enable the
Application Specific option to be able to have unique Wheel Sensitivity settings in each application you use. To
store settings, switch to your other application, open
EuControl Settings > General, and adjust the Wheel Sensitivity sliders for that
environment.