User guide

Artist Mix User Guide6
Removing the Riser Brackets
To remove the riser brackets from Artist Mix:
1 Slide the side panel towards the front of the unit, then pull it away).
2 Press the tabs to release the riser bracket and lift it out of the side panel.
Attaching an Artist Mix to Additional Units
Up to four Artist Mixes can be physically attached to each other to form a larger and more stable control surface. An Artist Control
and Artist Transport can also be joined to Artist Mix.
To join two Artist Mixes (or other Artist Series unit):
1 On one of the Artist Mixes, use a #2 Phillips screwdriver to remove the two silver screws. The screws may be tight, so you may
have to use some force.
Removing side panel from Artist Mix
Tabs to release the riser bracket from the side panel
If you are using multiple units, see “Surfaces” on page 27 to use EuControl to link the units in the desired order.
Removing screws from the bottom panel