Install guide

Media Application Controller Multiple Workstation Install Guide Pyramix
25
Leave the Station ID at its default setting of 1 unless you have multiple con-
trollers, in which case simply increment the setting (i.e., if two controllers are
installed, set the Station ID = 3 for the MC).
11. Press OK to exit that dialog, press OK on the Controller Properties dialog and
press OK on the General Settings dialog.
12. Close Pyramix, reboot the workstation, and then open Pyramix Virtual Studio.
Pyramix will not connect to the MC properly without rebooting the workstation.
The MC will now load the default Pyramix Application Set if a project is open. Other-
wise, the Application Set will not be loaded, but the Soft Keys at the top-left illuminate
to show that EuCon communication is enabled.