Specifications

Chapter 4: Configuring and Installing I/O in Stage 48 17
Installing Stage 48 in a Rack
Stage 48 can be installed in a standard 19-inch rack. When in-
stalling Stage 48 in a rack, it is recommended that you install
the included rear brackets for stability. Your rack must be
equipped with rear rack rails.
To install Stage 48 in a rack:
1 Slide Stage 48 into the rack.
2 Secure the front of Stage 48 to the rack using rack screws
(not included).
3 Using the included rear brackets, on the back of the rack line
up the bracket screw holes to the rack’s rear rails so that
Stage 48 sits on the rear bracket flanges.
4 Attach the rack brackets to the rear rack rails using rack
screws.
Make allowances for cooling air to be available to the
front panel surface side vents of the chassis enclosure.
There should also be no restrictions at the back of the
unit, especially around the back panel fan vents.