Specifications

Chapter 3: Configuring the DF66 11
Updating Software
Before updating software, start up the system with the existing
version of software.
To update eMix software:
1 Copy setup.exe to the System PC.
2 Uninstall the previous version of software by choosing
Start > Control Panel > Add/Remove Programs.
3 Delete the c:\emix folder.
4 Run setup.exe to install the latest version of eMix.
5 Enable a mixer model. This must be one of the LCC mixer
models.
6 Re-boot the System PC and the rest of the console.
To update DF66 software:
1 With the system running, start Internet Explorer by choos-
ing Start > Programs > Internet Explorer.
2 Type in the address http://192.168.0.200/cgi-bin/config.cgi.
3 Scroll down near the bottom of the page to Software.
4 Click Browse and select the file C:\eMix\SetupDF66.exe.
5 Click Upload. The DF66 installs new software and restarts.
The pilot goes off-line and returns to resync.
6 Re-Sync the system.
Compact Flash Recovery Image
To restore the DF66 system:
1 Download the file DF66 Rescue v1.01.zip.
2 Unzip the file and follow the instructions in readme.txt.
SP663 DSP Card Firmware
To check the firmware version of the DSP cards:
1 On the eMix diagnostics page, select Pilot 1.
2 Scroll down the page to make sure all cards say Firmware Re-
vision 16. (This may take a few attempts because the page
jumps to the top every few seconds when it refreshes.)
3 Update each card that does not say Firmware Revision 16
(described in the next section).
To update DSP card firmware:
1 Copy the lcupdate16.exe file to a USB drive.
2 Connect a keyboard and monitor to the DF66.
3 Power off the DF66 and restart it.
4 After the core restarts, go to the config web page
http://192.168.0.200/cgi-bin/config.cgi on the System PC.
5 Scroll down to Diagnostics and select Exit DSP App from the
list and click Do It. An empty command prompt is displayed
on the DSP Core.
6 Connect the USB drive to the DF66.
7 Type copy e:lcupdate16.exe d: and press Enter.
8 Type lcupdate16 and press Enter.
9 Click Next and the application shows the status of the cards
in the system.
10 Select all cards that need to be updated and click Next. The
update will take 5–10 minutes (a progress bar is displayed).
11 Click Finish when the update is complete and restart the
DF66.
12 Check the diagnostics page in eMix to see that all the cards
are now Rev 16.
Software Update window
Diagnostics window