User`s guide

DigiDrive Guide 14
6 Attach the SCSI terminator to the remaining
SCSI connector on the
last DigiDrive in the drive
stack (see Figure 10). Secure the terminator by
using the thumbscrews that are part of the ter-
minator.
7 Attach an ac power cord to the ac power con-
nector on the back of each DigiDrive.
8 Plug the ac power cords into a power strip.
9 If your system came with the dual-channel
board, repeat steps 1 through 8 to attach a sec-
ond SCSI chain to the system.
Connecting Wide and Narrow SCSI
Drives
The following procedure explains how to con-
nect a mix of wide and narrow drives.
To connect wide and narrow drives:
1 Attach the 68-pin SCSI connector on the sys-
tem cable to either SCSI connector on the
DigiDrive (see Figure 11). Secure the cable by us-
ing the thumbscrews that are part of the cable
connector.
2 If you are connecting a wide drive, locate the
SCSI cable with 68-pin connectors on both ends
in the drive kit.
3 Attach one end of the cable to the remaining
SCSI connector on the DigiDrive in the drive
stack (see Figure 12). Secure the cable by using
the thumbscrews that are part of the cable con-
nector.
Figure 10. Ultra, Wide SCSI Terminator Connection
To avoid bending pins, make sure the 68-
pin cable is perpendicular to the back panel
and properly aligned before inserting.
DigiDrive
Ultra, wide SCSI terminator
68-pin SCSI cable from computer's SCSI
host bus adapter or other drives
Figure 11. SCSI Cable to DigiDrive Connection
Figure 12. Additional Wide Drive Connection
DigiDrive
68-pin SCSI cable from computer's
SCSI host bus adapter
4
DigiDrive
Wide drive
68
-
pin to 68-pin
15-inch SCSI cable
68-pin SCSI cable from computer's SCSI
host bus adapter or other drives