User`s guide

Chapter 3: Installation 13
Connecting Only DigiDrive
Enclosures
The following procedure explains how to con-
nect a DigiDrive. Stack the drives before connect-
ing any cables and turning the drives on.
To connect DigiDrive enclosures:
1 Attach the 68-pin SCSI connector from the
computer's SCSI host bus adapter to either SCSI
connector on the DigiDrive
2 If you have more than one DigiDrive, locate
the SCSI cable with 68-pin connectors on both
ends in the next drive kit.
3 Attach one end of the cable to the remaining
SCSI connector on the first DigiDrive in the
drive stack (see Figure 9). Secure the cable by us-
ing the thumbscrews that are part of the cable
connector.
4 Repeat steps 2 through 5 until you have all the
drives connected.
5 Attach the other end to either SCSI connector
on the next DigiDrive in the drive stack. Secure
the cable by using the thumbscrews that are part
of the cable connector.
To avoid bending pins, make sure the 68-
pin cable is perpendicular to the back panel
and properly aligned before inserting.
Figure 8. SCSI Cable to First DigiDrive Connection
DigiDrive
68-pin SCSI cable from computer's SCSI
host bus adapter or other drives
Figure 9. Additional DigiDrive Connection
DigiDrive
68
-
pin to 68-pin
15-inch SCSI cable
68-pin SCSI cable from computer's SCSI
host bus adapter or other drives