User`s guide

Chapter 3: Installation 11
4 Swing the locking plate on each side of the
bottom drive 90 degrees (to a horizontal posi-
tion) and tighten the locking plate screw (see
Figure 6).
5 Swing the locking plate on the top drive 180
degrees so that the upper hole in the top locking
plate aligns with the upper hole in the bottom
drive.
6 Replace the screw into the top hole in the bot-
tom drive so that the top and bottom drives are
secured to each other (see Figure 7).
7 Replace the remaining screw into the top hole
in the top drive.
8 Repeat steps 5 through 7 for the other side of
the top drive.
9 Repeat this entire procedure if stacking a third
and fourth drive.
When more than four drives are used, consider
creating two drive stacks. In order to prevent the
stack from toppling over, be sure to stack the
drives with the largest units on the bottom.
If you have the dual-channel SCSI accelerator
board or two single-channel SCSI accelerator
boards, you might want to arrange the drives in
two separate stacks; one stack for each SCSI
chain. Attach the drives to the system one group
at a time.
Figure 5. DigiDrive Locking Plate
Figure 6. Bottom Drive Locking Plate
2
1
MediaDrive
rS18 Plus
MediaDrive
rS18 Plus
Top locking plate screw
Bottom locking
plate screw
2
1
MediaDrive
rS18 Plus
MediaDrive
rS18 Plus
Bottom locking plate
turned 90 degrees
A
Figure 7. Secured DigiDrive Enclosures
2
1
MediaDrive
rS18 Plus
MediaDrive
rS18 Plus
Top locking plate
turned 180 degrees