Car Video System User Manual

Chapter 3: Basic Media Station|PT Workflows 57
6 In the existing sequence, choose any of the
following methods to set the starting position at
which the selection in the Source Monitor will
be added:
• Drag the cursor in the Timeline to the de-
sired position.
• In the Record Monitor, use the controls
(similar to the Source Monitor controls) to
queue to the desired position.
• In the Timeline or the Record Monitor,
press the Home key to move to the begin-
ning of the sequence, or press the End key
to move to the end of the sequence.
7 Choose one of the following methods to add
the selected portion of the clip at the location of
the cursor:
• Click the Overwrite button to paste the se-
lected clip over any existing material in the
Timeline.
– or –
• Click the Splice-In button to paste the se-
lected clip into the Timeline, and push all
the clips which come after the insertion
point later in the Timeline (analogous to a
Shuffle edit in Pro Tools).
8 To add another clip to the sequence, repeat
the preceding steps.
Deleting Clips from a Sequence
When you delete a clip from a sequence, all se-
lected (purple) audio and video track layers of
the clip are removed from the sequence.
To delete clips from a sequence:
1 In the Timeline, click the clip you want to de-
lete so that the cursor appears between its
boundaries.
2 Click the Track Enable buttons on the left side
of the Timeline so that all audio and video tracks
in the Timeline are selected (purple).
3 Above the Timeline, do one of the following:
• Click the Mark In and Mark Out buttons to
set the In and Out points.
– or –
• Click the Mark Clip button to automati-
cally highlight the entire clip.
Overwrite and Splice-In buttons
OverwriteSplice-In
Cursor in clip boundaries in Timeline
Track Enable buttons
Record Monitor controls
Timeline
Track
Enable
buttons
Source
Track
Enable
buttons
Mark
Out
Mark
In
Mark
Clip