Car Video System User Manual

Chapter 4: Media Station|PT Video Satellite Workflows 127
3 Use the Mark In and Mark Out controls to se-
lect a specific portion of video you want to cap-
ture from tape, and click Record. (See “Selecting
a Portion of Video to Capture” on page 127.)
After you click Record, Media Station|PT cues
the VTR. Media Station|PT and Pro Tools drop
into record mode at the appropriate moment.
The flashing red light indicates recording is in
progress.
4 Click the Record button again (or press the
ESC key) to stop.
Playing Back Captured Audio and Video
with a Video Satellite System
Once you have finished capturing with a video
satellite system, the captured clip appears in the
Record Monitor and in the Timeline. Audio ap-
pears in the Pro Tools Timeline.
To view the captured clip, do the following:
 Click Play (or press the Spacebar) in Pro Tools
or Media Station|PT.
Selecting a Portion of Video to Capture
The Mark In and Mark Out controls in the Cap-
ture Tool let you select a portion of video to cap-
ture from the tape.
Mark In and Mark Out controls (and Record button)
If Media Station|PT displays an error mes-
sage regarding mis-matched frame rates,
you may have mis-matched time code for-
mats or play rates. See “Matching
Media Station|PT and Pro Tools Settings in
a Video Satellite System” on page 115 for
detailed information on correcting the con-
figuration.
You can capture without first entering an In
point, but this is not advised because of un-
predictable delays between clicking the
Record button and actually capturing video.
Mark Out
Duration
Mark Memory Go To Memory
Go to In
Go to Out
Mark In
Clear
Display
Record
During recording, video may appear out of
synchronization with audio. However, au-
dio and video will be synchronized during
playback.