Specifications

Pro Tools Reference Guide474
4 Make sure you are actively writing on the ap-
propriate track if you are in Latch or Touch
mode.
5 When you reach a point in the track or selec-
tion that contains the automation data you
want to apply, click Write to Start, Write to All,
or Write to End in the Automation Enable win-
dow.
The current values of all write-enabled automa-
tion at that point are written to the correspond-
ing area of the track/selection.
Trim Mode
Using Trim mode, it is also possible to write trim
delta values for track volume and send levels to
the start (beginning), end or all of a track.
To write current trim delta values to the start, end,
or all of a track or selection:
1 In the Automation Enable window, make sure
that the automation type (track volume or send
level) is write-enabled.
2 Click the Automation Mode Selector on the
track. Select Trim from the pop-up menu to en-
able Trim mode. The track volume and send
level faders turn yellow.
3 Click in a track at an insertion point.
– or –
Drag with the Selector to select a portion of the
track.
4 Click Play to begin playback.
5 When you reach a point in the track or selec-
tion that contains the trim setting (delta value)
you want to apply, click the Write to Start, Write
to All, or Write to End button in the Automation
Enable window.
The relative changes to the track volume and
send levels at that point are written to the corre-
sponding area of the track/selection.
Write to Start, End, and All On
Stop
The Automation Enable window provides op-
tions for automatic Write to Start, End, and All
On Stop.
To configure Write on Stop:
1 Open the Automation Enable window.
2 Click to enable one of the Write On Stop
modes (Start, End, or All).
When any of these options are enabled, auto-
mation writing will be performed automatically
after a valid automation pass has been per-
formed. See “Requirements for Write to Start,
End, and All” on page 473.
Write On Stop controls in the Automation Enable
window
Write on Stop