Specifications

Chapter 20: Record Setup 445
Assigning Hardware I/O on a
Track
Before recording to a track, you must specify the
input and output signal path for the material you
are recording. You will do this by assigning a hard-
ware input (recording source) and an output bus
(for monitoring recording) on the track.
To assign I/O on a track:
1 Assign a hardware input (recording source) by
doing one of the following:
• In the Mix window, select the corresponding
hardware input for your source from the track’s
Input Path selector.
• In the Edit window, with I/O view enabled, se-
lect the corresponding hardware input for your
source from the track’s Input Path selector.
2 Assign an output bus (for monitoring recording)
by doing one of the following:
• In the Mix window, select the corresponding
output bus for monitoring (such as “Monitor” or
“A 1–2”) from the track’s Output Path selector.
Input Path selector, Mix window
Input Path selector, Edit window
Output Path selector, Mix window