Specifications

Chapter 7: I/O Setup 105
Signal Path Routing for Audio Output
The following example shows the signal path from the output of an audio track through an output bus
mapped to an output path that is routed to a physical output on an HD I/O audio interface:
(1) Track Output Audio is played back from disk
and routed from the Track Output to Output Bus
“B 1–2.”
(2) Output Bus Path The Output Bus is defined on
the Bus page of the I/O Setup. On the Bus page of
the I/O Setup, the Output Bus “B 1–2” is mapped
to Output “B 1–2,” which is defined on the Output
page of the I/O Setup.
(3) Output Path On the Output page of the I/O
Setup, the Grid is used to route the output path (to
which the output bus is mapped) to physical out-
puts.
(4) Physical Output For Avid HD audio interfaces,
such as the HD OMNI, the physical outputs that
are available to Pro Tools are set on the Main page
of the Hardware Setup (this selector is mirrored in
the Output page of the I/O Setup).
Output signal path from an audio track to a physical output as mapped in I/O Setup
3
4
2
1