Specifications

Chapter 6: System Setup 83
Configuring 96 I/O Controls
To configure controls for a 96 I/O:
1 With the 96 I/O selected in the Peripherals list,
configure your I/O front panel meters for input
or output metering from the Meters pop-up.
2 Click the Analog In tab for the following
option:
• You can set your operating level on a channel-
by-channel basis by selecting Reference Level
+4 dBu or –10 dBV. See the 96 I/O Guide for
more information on setting operating levels.
3 Click the Analog Out tab for the following op-
tion:
• You can set your output level on a channel-by-
channel basis by selecting
Reference Level
+4 dBu
or –10 dBV. See the 96 I/O Guide for
more information on setting
operating levels.
Configuring 96i I/O Controls
To configure controls for a 96i I/O:
1 With the 96i I/O selected in the Peripherals list,
configure your I/O front panel meters for input
or output metering from the Meters pop-up.
2 Set input sensitivity by doing the following:
• For Inputs 1–4, set the input trim slider to match
the output level of the connected instrument.
Choices range from –12 dBV to +4 dBu. If you
do not know the output level of the device, use
the default input trim level, then fine tune the in-
put level sensitivity.
• For each input 5–16 being used, select –8 dBV
or +4 dBu as appropriate to best match the out-
put level of the connected instrument.
3 Set Output levels (select –10 dBV or +4 dBu).
4 Click Done.
You can select analog or digital input as sources
for 96i I/O channels 1–2. Only channels 1–2 can
access the S/PDIF inputs.
Hardware Setup for 96 I/O, Analog In page
Hardware Setup for 96 I/O, Analog Out page
Hardware Setup for 96i I/O