Specifications

Getting Started with MIX46
882|20 I/O Controls
• Input and Output Reference Level can be set
to +4 dBu or –10 dBV
• Channel 1–2 I/O pair can be set to Analog or
Digital
• S/PDIF Format can be set to Tascam DA-30 or
Other
1622 I/O Controls
• Input levels can be varied continuously be-
tween Reference Levels of +4 dBu to –10 dBV
• Output levels can be set to Reference Level
+4 dBu or –10 dBV
• Channel 1–2 I/O pair can be set to Analog or
Digital
• S/PDIF Format can be set to Tascam DA-30 or
Other
ADAT Bridge I/O Controls
For information on configuring the Hardware
Settings for the 24-Bit ADAT Bridge I/O or the
original ADAT Bridge I/O, refer to the guide that
came with that interface.
Configuring I/O Setup
The I/O Setup dialog provides a graphical repre-
sentation of the signal routing for each con-
nected audio interface. The I/O Setup dialog also
lets you label and map Pro Tools input, output,
insert, and bus signal paths.
Each Audio Interface attached to your system is
displayed, with controls to route physical ports
to Pro Tools inputs and outputs. If you have a
TDM-equipped SampleCell card in your system,
you can also configure its signal routing in the
I/O Setup dialog.
Pro Tools has default I/O Setup settings that will
get you started. You only need to go to I/O Setup
if you want to remap or rename the default I/O
paths.
Hardware Setup dialog for 882|20 I/O
Hardware Setup dialog for 1622 I/O
I/O Setup dialog for 888|24 I/O, Input page