Specifications

Getting Started with MIX104
Other Options Button and Recalibrate Button
The behavior of these buttons depends on the
peripherals you have connected. Refer to the
documentation for your specific audio interface.
B: No Interface tab
If you have two peripherals connected to your
d24 or MIC Core card, you may select and con-
figure the “B” peripheral using the controls un-
der this tab. These settings will only be relevant
to Pro Tools, and not the WaveDriver. For more
detail, see “Installing the WaveDriver” on
page 99.
Card Info tab
Bus, Slot Number
These controls display card specific PCI bus in-
formation and should not be altered.
Installing DigiGain
DigiGain is an optional volume control applet
that allows you to control the master output of
your Digidesign audio interface as well as con-
trol the monitoring input levels of the
WaveDriver independently from your third-
party audio application. By default, the master
level is set to 0 dB.
DigiGain is not available as a volume control on
the Windows task bar. As a result, the following
settings will be disabled in the Multimedia con-
trol panel under the Audio tab: “Show volume
control on the taskbar,” the playback volume
control, and the recording volume control will
all be disabled.
Before installing DigiGain
The WaveDriver must be installed before install-
ing DigiGain. If you did not install the
WaveDriver or reboot the computer after install-
ing the WaveDriver, do so now.
Installation Instructions
To install DigiGain:
1 Insert the Pro Tools Installer CD.
2 Locate DigiGain.exe on the CD, and copy to
the Desktop.
Removing DigiGain
To remove DigiGain:
1 Delete (move to Recycle Bin) DigiGain.exe
from the Desktop.
2 Empty the Recycle Bin.