Specifications

Appendix F: Digidesign WaveDriver (Windows Only) 103
I/O Setup Dialog
Click the Advanced button in the WaveDriver
Settings to open the I/O Setup dialog:
A: No Interface tab
Peripheral Type
Please choose the (“A”) peripheral you have
connected to your d24 or MIX Core card.
Sample Rate
Available sample rates are 48000 Hz and
44100 Hz. You do not need to change the sam-
ple rate in this dialog before playing or record-
ing a file with a new sample rate. If you are play-
ing a file, it will automatically play back at the
correct sample rate. If you are recording a new
file, simply choose the desired sample rate using
the audio application's Preferences or Record
Options dialog.
Sync Mode
Sync mode may be set to Internal or Digital and
is Internal by default.
Digital Format
If your peripheral is an 888|24 I/O or an 888 I/O,
this control may be set to AES/EBU or S/PDIF
and is AES/EBU by default. If your peripheral is
an 882|20 I/O, an 882 I/O, or a 1622 I/O, this
control will be set to S/PDIF and will be grayed
out.
Ch 1–2 (Format)
This control may be set to Analog or Digital. It
determines whether the WaveDriver plays and
records through your peripheral's analog or dig-
ital I/O. The WaveDriver can only play and
record through channels 1–2 of your selected
peripheral.
Identify Check Box
This control enables you to verify which periph-
eral you are configuring for use with the
WaveDriver. Checking this box causes all the
meters on the connected peripheral to light up.
Figure 6. I/O Setup dialog