User`s guide

Chapter 2: Installation and Setup
58 Pinnacle Systems DekoMOS User’s Guide
2. Double click any row to add or delete GPI actions assigned to the corresponding GPI trigger.
Note: A discussion about choosing commands followed by a command reference table begins on page 59.
The Editing GPI dialog appears.
3. Add, reorder, or Remove commands from the GPI trigger.
• To Add a command, click to highlight the command in the Available Commands list, then click the
Right Arrow button to enter the command in the Command Order list.
• To reorder commands, click to highlight a command in the Command Order list, then click the Up
or Down arrow button to change the position of the command in the list.
• To remove a command so that it is no longer assigned to the GPI trigger, click to highlight the
command in the Command Order list, then click the Remove button.
For each External GPI Assignment triggered by tally pulses, a Tally On and a Tally Off
condition can be set. Actions in the Tally On column are triggered if the appropriate channel is
tallied on at the switcher. Actions in the Tally Off column are triggered if the appropriate
channel is tallied off at the switcher.
IMPORTANT: Unpredictable results can occur if tally or GPI pulses are received before a designated
action, such as Play Next, is completed. Therefore, be sure to allow adequate time between tally and/or GPI
triggered effects.
4. Click OK.