User`s guide

Chapter 2: Installation and Setup
Pinnacle Systems DekoMOS User’s Guide 57
2. Click to check or uncheck Enabled. If Enabled is checked, You should see the message Port
opened.
3. Click OK.
To configure commands invoked by a GPI signal:
1. From the Playback Controller interface, click Configuration>GPIs>Assignments.
The GPI Assignments dialog appears. This dialog allows you to assign commands to GPI
triggers
The two rows below Local GPI Assignments correspond to single GPI triggers connected to
USB ports.
The ten rows below External GPI Assignments correspond to the ten buttons on the Burst
Electronics GPI-10.