User`s guide

Appendix B: Connect Tally and GPI Control
Pinnacle Systems DekoMOS User’s Guide 161
1. Use the hardware connection instructions on page 158 as a general guide for executing the
following steps.
2. Connect Deko Video Outputs 1 and 2 to switcher inputs, typically through a patch field or
router. Note that Deko Key Outputs 1 and 2, although not shown in the diagram, are also
connected to switcher inputs.
3. Connect tally outputs from each switcher, corresponding to Deko Video Inputs 1 and 2 to their
respective tally matrices and distribute to monitors, Under Monitor Displays, and other
appropriate devices.
4. Connect a matrix output for each Deko video channel to a GPI input on one of two Burst GPI-
10 Converters.
5. Connect switcher output GPIs to the remaining inputs on each Burst GPI-10 Converter.
6. Connect the RS-232 output of each Burst Converter to COM-1 of the DekoMOS Playback
Controller assigned to the Control Room.