User`s guide

Chapter 5: Controlling Playback
130 Pinnacle Systems DekoMOS User’s Guide
• Choose Auto Cue to specify that the next item automatically cues when an item plays.
To control how a channel responds to tally signals:
In the Channel Setup dialog, use the Receive Tally Feedback and the Enable Tally Commands
checkboxes.
With Receive Tally Feedback checked and Enable Tally Commands checked, all tally and GPI
commands are executed.
With Receive Tally Feedback checked and Enable Tally Commands unchecked, only
commands affecting tally condition, such as Tally On, Tally Off, and Enable Tally, are
executed.
With Receive Tally Feedback unchecked and Enable Tally Commands unchecked, the channel
does not receive or recognize tally commands.
GPI Configuration
You can configure the Playback Controller to accept GPI signals. These GPI signals can be
invoked manually or triggered by tally condition. For additional information about configuring
GPI commands, see page 59. For information about hardware connections, refer to the Appendix
beginning on page 157.
Playing Graphics in a Show
The DekoMOS Playback Controller automatically progresses through a show when you press the
Spacebar or Enter. For flexibility, items in the rundown may be individually selected, then cued,
and played to air. The Playback Controller will indicate by color if a file is missing and you can
search for missing files. Additional graphics that are not in the rundown can be played to air also.
From the rundown, an operator can change the playout channels for Deko graphics.
Note: Playout channel control is currently available only with ENPS systems.
To open a rundown:
From the initial Playback Controller interface displaying a list of rundowns, do one of these:
• Double-click on a show name.
• Press the Up or Down arrow key, and then press Enter to select a show name.