User`s guide

Check List for K2 Media Server Setup
7
Check List for K2 Media Server Setup
When adding a K2 media server to your workgroup for ingesting or send to playback, you
need to setup the K2 media server.
Check List for Adding a K2 Server for Ingest
When adding a K2 server to your workgroup for ingesting media, you need to configure the
Interplay Transfer settings and create a FTP server profile.
Task Description

Read the important information section
before adding a K2 media server to your
workgroup.
See “Important Information” on page 2.

Make sure you have the correct version of
the K2 media server.
For the Interplay Transfer v1.6.1 release, the K2
version is v3.2.74.1031. For information about
version numbers that might have changed after
this document was release, see the Interplay
ReadMe.

Setup user accounts on the K2 media server. See “K2 User Accounts and Folder
Permissions” on page 5.

Create an ingest and a send to playback
folder on the K2 media server.
See “K2 User Accounts and Folder
Permissions” on page 5.
Task Description

Read the important information section
before adding a K2 media server to your
workgroup.
See “Important Information” on page 2.

Setup the K2 media server. See “Check List for K2 Media Server Setup” on
page 7.

Create a FTP server profile for the K2 server
and the type of media you want to ingest.
See “Configuring an FTP Server Profile for
Ingest From a K2 Server” on page 14.

In the Interplay Transfer Engine
Configuration Tool, add the K2 server to the
Ingest list.
See “Adding a FTP Server Profile for Ingesting”
on page 17.