Setup guide

EUCON Application Setup Guide32
Tips and Shortcuts
Insert and Control Any Plug-In
Placing plug-ins on a track and controlling them from the Artist media controller can speed up your workflow. Controlling a plug-in
with knobs instead of a mouse not only provides more intuitive, higher resolution control, but can also control multiple parameters
simultaneously. You can dial in settings or automate plug-in control without mousing around or drawing lines in the arrange win-
dow.
To work with plug-ins:
1 Select a track on the Artist media controller.
2 Press the INSERTS key (Artist Mix) or the INSERTS Knob Top (Artist Control).
3 Press both PAGE keys (<PAGE and PAGE>) simultaneously to enter Config mode.
4 Push the Knob Top beside the Insert you wish to assign the plug-in to. To see other available plug-ins, press <PAGE or PAGE>.
5 Press the Knob Top to select that plug-in.
6 Press both PAGE keys simultaneously to exit Config mode.
7 Press CHAN to access parameters for the plug-in.
8 Push the Knob Top to open the plug-in.
9 Control plug-in parameters; press the PAGE keys to access more.
10 Press the BACK key to close plug-in.
Flip to Faders (Artist Mix)
Flipping the plug-in's parameters from knobs to faders lets you change eight parameters simultaneously. Flipping bus sends to fad-
ers makes it easier to send multiple signals to an effect and better controls effects textures in your mix.
To flip to faders:
1 Select a track on the Artist media controller.
2 Press the INSERTS knob set selector (Artist Mix) or the INSERTS Knob Top (Artist Control).
3 Press a Knob Top to open a plug-in.
4 Press the FLIP key (SHIFT+CHAN/FLIP) to flip the knobs to the faders. You can now control the plug-in on the faders.
5 Press SHIFT+CHAN/FLIP again to flip the faders back to the knobs.
6 Press the BACK key to close the plug-in.
Flip also works for
AUX, PAN, EQ, and other knob sets.
Examples in this section may require Digital Performer 7.2.2 or higher.