Setup guide

Chapter 9: Sequoia 27
Chapter 9: Sequoia
You can use Artist Series controllers with Sequoia (version 11.02 or higher) from Magix.
To setup and configure EUCON for Sequoia:
1 Navigate to Programs\Magix\Samplitude\Customize\Eucon, and copy the files “Sequoia.xml” and “Sequoia_x64.xml” to Pro-
grams\Euphonix\EuCon\SQRL, or to the location where your user templates are located
2 Launch Sequoia and open or create a new project.
3 Choose Options > System/Audio...
4 Under System Options, click Hardware Controller.
5 In the EUCON section, click to enable Activate EuCon.
6 Click Reset connection.
7 Click Apply.
8 Click OK.
9 Restart EuControl.
10 Power cycle all Artist Series controllers.
11 Launch Sequoia.
Always check with the manufacturer of your specific application for the most recent software, requirements, and instructions.
Sequoia Hardware Controller window