Setup guide

Chapter 5: Logic Pro 17
Chapter 5: Logic Pro
Logic Pro from Apple works with your Artist media controller with very little additional setup. Make sure the EuControl software
is running. Launch Logic Pro and click in a Logic window so it is the front-most application. Your surface now controls Logic Pro.
To make sure your Artist media controller works correctly with Logic Pro:
1 In Logic Pro, choose Logic Pro > Preferences > Control Surfaces > Setup... The Logic Control Surface Setup window appears.
2 In Control Surface Group 1 on the left side of the window, locate Channel Strip View Mode (fourth parameter from top).
3 Set this parameter to Arrange.
Tips and Shortcuts
Instantiate and Control Any Plug-in
Placing plug-ins on a track and controlling them from the Artist media controllers can speed up your workflow. Using knobs in-
stead of a mouse to control a plug-in not only provides more intuitive, higher resolution control, but also enables simultaneous con-
trol of multiple parameters. You can dial in settings or automate plug-in control without mousing around or drawing lines in the ar-
range window.
To insert a plug-in:
1 Select a track on the Artist media controller.
2 Press the INSERTS key (MC Mix) or the INSERTS Knob Top (MC Control).
3 Press both PAGE keys simultaneously to enter Config mode.
4 Push the Knob Top beside the Insert you wish to assign the plug-in to.
5 Push the type for the type of plug-in you wish to instantiate.
6 Press the Knob Top to select the actual plug-in.
7 Press the Knob Top to select the channel format.
8 Press both PAGE keys simultaneously to exit Config mode.
9 Push the Knob Top to open the plug-in.
Always check with the manufacturer of your specific application for the most recent software, requirements, and instructions.
Logic Control Surface Setup window