User guide

Chapter 2: Installation and Setup 7
7 Plug one end of the Ethernet crossover cable into the Ethernet jack on the back panel of the MC Transport.
8 Plug the other end of the Ethernet crossover cable into an available Ethernet jack on your computer, router, or Ethernet switch.
• Note that connecting directly to the computer may require removing your Internet cable. If you have a computer with two
Ethernet ports, use Ethernet 1, rather than Ethernet 2.
• An Ethernet router or switch is required to connect additional Artist Series media controllers, or to connect units to a local
area network.
9 Turn on your router (if applicable), then turn on your computer and wait until it finishes starting up.
Ethernet cable and rear panel jack
MC Transport connected directly to a computer
MC Mix and one MC Transport connected to a computer through an Ethernet router (or switch)