User guide

Chapter 11: DAW Integration 95
4 Click the + button.
5 Select Mackie Control from the Control Surface Type pop-up menu.
6 For the Input and Output Connection pop-up menus, select the MIDI send and receive ports. These will be the same port, so
if Soundtrack Pro uses ports 5–8, the first controller sends and receives on port 5.
7 Click OK to close the Add Control Surfaces dialog.
8 Repeat the process to add up to four controllers.
9 When finished adding controllers, click the OK button to close the dialog in Final Cut Pro. In Soundtrack, click the Close button
at the top left to close the Preferences.
10 Restart the application or computer if initial communication is not achieved. The MC connects and updates with new track
information.
Digital Performer 5
Configuring Digital Performer 5 to operate with the MC using Mackie Control
1 Open Audio/MIDI setup.
2 Create up to 4 Mackie Controls and cable to the Euphonix MIDI ports as defined in EuPrefsPane.
3 In Digital Performer, do the following:
•Go to Setup > Control Surfaces.
• Add one Mackie Control and select the first Mackie Control from the MIDI menu.
• Add any additional units as Expander (XT) modules.
Add Control Surface dialog
For System 5 MC owners, remember the MC mirrors one CM408T module, so up to four CM408T modules can be used with one MC.
Digital Performer Midi Devices