User guide

Chapter 11: DAW Integration 89
Accessing Knob Sets
CM408T
The eight knobsets are accessed directly from each channel strip.
• INSERT, GRP, EQ and DYN knobsets provide access to the DSP Edit / Assign controls of the corresponding channel using the
8 knob cells of that strip.
• Pan, Aux, Input and Mix are global. These knobsets will toggle the display on all channels on the surface. Additionally, these
knobsets use only the bottom knob cell (8).
• The default knobset is PAN.
MC Soft Knobs
The eight soft-knobs on the MC Pro can also be used to access the eight knobsets. By default, this section will display parameters
specific to the attentioned track. The default knobset is always PAN.
To access other knobsets press BACK. The 8 LCD displays will now show the eight knobsets. Press the corresponding LCD button
or knob-top to enter the desired knobset.
INSERT (*)
The INSERT knobset will display the inserts on the attentioned channel. The INSERTS will be displayed on knob cells 5-8.
To assign inserts:
1 Press CFG.
2 Turn knob on desired insert.
3 Press ON button (flashing green)
4 To cancel press CFG without assigning or return to PAN knobset.
To unassign inserts:
1 Press CFG
2 Turn desired insert knob to No Insert.
3 Press ON to assign No Insert.
Modifiers work as normal (OPT = do to all, OPT+SHFT = do to all selected)
INPUT
The INPUT knobset shows currently assigned inputs. All surfaces will display this in NORMAL mode across all channels.
To assign input:
1 Turn knob to desired Input.
2 Press ON to assign (flashing green). Modifiers work as expected: To cascade inputs across multiple selected tracks, hold
Opt+Shift+Command (Mac) and assign.
DYN
The DYN (dynamics) displays the first dynamics plug-in on the knobs. It is important to note that DYN knobset is simply a special
case mapping of parameters from the INSERT knobset. This is dedicated to provide control of dynamics plug-ins in a way that is
consistent with other EUCON enabled DAW systems.
If no dynamics plug-in exists, the channel defaults back to INSERTS view.