User guide

MC Pro User Guide80
4 Click Controller. The right pane shows any installed controllers. However, at this point the pane is empty unless other interface
controllers have been installed previously.
5 Click the Add button.
6 Type the desired name for the MC in the Name field (for example, type “MC in Studio 2”).
7 Select the Enable checkbox.
8 Choose OASIS from the Driver pop-up menu.
9 Click the Properties button next to the Driver pop-up menu.
10 Select EUCON from the Transport pop-up menu.
If EUCON is not in the pop-up menu, it is probably because the MC Client is not running. Check that the MC Client menu tray
icon is present. If not, launch the MC Client using the shortcuts in the Start menu or the Euphonix folder. Leave the Station ID
at its default setting of 1 unless you have multiple controllers, in which case simply increment the setting. For example, if f two
controllers are installed, set the Station ID = 3 for the MC.
11 Click OK to exit that dialog, click OK in the Controller Properties dialog and click OK in the General Settings dialog.
12 Close Pyramix, reboot the workstation, and then open Pyramix Virtual Studio. Pyramix will not connect to the MC properly
without rebooting the workstation.
The MC loads the default Pyramix Application Set if a project is open. Otherwise, the Application Set will not be loaded, but the
Soft Keys at the top-left illuminate to show that EUCON communication is enabled.
Controller Properties dialog
OASIS Configuration Properties dialog
Since the MC only accesses the functions of Pyramix Virtual Studio, this manual does not document those functions. Refer to the
Pyramix Virtual Studio manual for specific information.