User guide

MC Pro User Guide76
Monitor Setup
The Monitor Setup key opens the Monitor Touchscreen, which controls the source for each Studio feed. Each Studio feed has its
own tab (Monitor A–D), and each tab lists the possible sources (External Input, Main, and Aux busses). To select a source for a
Studio bus, touch the tab of the desired bus then touch the source to assign; source selections intercancel.
Talkback
Once the Talkback bus is set up, pressing the MC Talkback button automatically dims all output bus levels and routes the Talk-
back bus output to all output busses with TE enabled in the Nuendo Control Room Mixer (green when enabled). To utilize the
MC built-in talkback mic, connect the XLR talkback mic output on the back panel to an input on your Nuendo workstation hard-
ware (ASIO sound card), then select that input as the source for the Talkback bus (Device Port in the Studio tab of the VST Devices
window). The MC built-in talkback mic is a condenser microphone and requires 48-V phantom power.
Nuendo-Specific MC Controls
This section discusses MC controls that have a unique function within Nuendo.
Soft Keys
Soft Keys may be programmed with three Nuendo-specific commands by selecting MC type commands.
Parameter Collect Stores automation data into the MC internal memory buffer for punching into Nuendo’s automation system
at specified locations.
Parameter Punch Transmits automation data collected into the MC internal memory.
Read/Write All Automation Used in conjunction with Parameter Collect and Parameter Punch to isolate automation system from
automation being collected into the MC internal memory buffer.
Monitor Touchscreen
The rear panel Foot Switch jack can be used to toggle Talkback on/off (see “Other Connections” on page 8).