User guide

MC Pro User Guide72
Avid Pro Tools
Pro Tools 9.0 and higher is fully EUCON-aware.
Enabling EUCON in Pro Tools
To enable EUCON control in Pro Tools:
1 Launch Pro Tools.
2 Choose Setup > Peripherals, and click the Ethernet Controllers tab.
3 Select Enable EUCON.
4 Click OK. You do not need to configure any other Ethernet Controllers settings. These settings do not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible controllers. When Pro Tools finishes scanning your
system, your controllers are ready to use with Pro Tools.
Confirming Communication with Pro Tools
To confirm installation and communication:
1 Open a session if one is not already open.
2 Verify that the Mix window displays a border around the names of the Pro Tools tracks that are currently displayed on the
MC Pro Surface.
3 Verify that the displays on your controllers show track names, location, or other session data, depending on the configuration
of your MC Pro or System 5 MC.
Pro Tools Setup > Peripherals > Ethernet Controllers
Track name color to indicate control by MC Pro (number of tracks under simultaneous control varies with MC Pro/System 5 MC configuration)