User guide

MC Pro User Guide46
Chan Select Key
Press the Chan Select key to select the channel assigned to that strip. When lit, this channel is selected in the DAW for editing.
Press the Chan Select key to select a workstation track; it lights when a track is selected. The workstation’s tracks or mixer window
scrolls to show the most recently selected track.
Select Key
When pressed by itself, the Select key toggles automation Write mode on/off for the track.
LEDs
The green R and red W LEDs are used to denote the automation modes shown in the table, below.
To set the automation mode:
 Press and hold the Wave key and press the Select key to select from the popup menu. In Write mode, the red W LED blinks
when writing automation and is solid otherwise.
Automation Modes
In Write mode, the red LED blinks when writing automation, and lights solid when the transport is stopped.
Wave Key
Press the Wave key to focus a track to the MC Soft Knobs for channel editing. If Select most recently attentioned track is selected
in the Preferences-General Touchscreen, this will also select the track in the DAW. The Wave key stays lit to indicate it is the
attentioned channel.
Wave + Select
Press the Wave and Select keys simultaneously to display the DAW automation mode on the MC Touchscreen for that track.
Wave + Chan Select
Press the Wave and Chan Select keys simultaneously to assign a track to a strip. This technique is called Direct Assignment.
Fader
When a workstation channel is assigned to a strip, the fader controls the workstation track’s fader.
Mode R LED (green) W LED (red)
Isolate off off
Read on off
Write off on
Read + Write on on
The yellow G LED is reserved for future use.