User guide

Chapter 2: Installation and Configuration 13

System 5 MC

The CM408T modules do not allow static IP addressing. Use a DHCP server to auto-assign their IP addresses. The SonicWALL PRO

1260 router (or other) included in the System 5 MC system is set to perform this function by default.

To set up the System 5 MC network, connect the MC and CM408T modules to the SonicWALL 1260. (or other router included

with your configuration). The SonicWALL 1260 auto-assigns their IP addresses. The MC can now recognize the CM408T modules.

See “Modules” on page 16 to configure the MC to control the CM408T modules.

The SonicWALL 1260 (or other) included router is shipped with all default settings unchanged. To log into the SonicWALL: User-

name: admin Password: euphonix. The SonicWALL 1260 checks for a DHCP server on the LAN to which it is attached. If a DHCP

server is not found, it enables its own internal DHCP server.

To access the SonicWALL web configuration interface:

1 Connect a workstation to one of the 1260 LAN ports.

2 Set the workstation to obtain an IP address automatically using DHCP.

3 Open a web browser and type 192.168.168.168 (the router’s default IP address) into the location address field.

4 Log in to the SonicWALL: Username: admin Password: euphonix The SonicWALL Setup Wizard then launches to configure the

router settings.

Refer to the SonicWALL 1260 manual (included with your System 5 MC or available at SonicWALL’s website) for more informa-

tion on router settings. Consult your network administrator to find appropriate settings for your LAN.

Workstation Control

The MC can control up to four workstations using the Workstation keys.

To assign Workstations:

1 Press the Strip Control Setup key on the right side of the MC.

Workstation keys

Workstation

Strip Control Setup key

Strip Control

Setup

Flip

Home

Nudge