User guide

MC Pro User Guide12
4 Click Apply when you are done.
This configuration is only necessary with HUI and Mackie Control applications. EUCON-aware applications communicate auto-
matically with the MC. MC Client enables the MC’s keyboard, trackball, and Soft Keys to control all non-EUCON-aware applica-
tions just as the keyboard and mouse.
MC Client and EUCON Discovery Options
On Mac, MC Client launches on startup and runs invisibly if the EuPrefsPane is active.
To enable or disable MC Client and EUCON activity:
 Open the EuPrefsPane and click the Start/Stop button at the bottom of the window. EUCON defaults to active when installed.
When Windows loads, MC Client and EUCON Discovery services automatically start, and their icons appear in the system tray.
In Windows, Right-click the EUCONDiscovery icon in the system tray for these options:
EUCON Network
This lists each installed network card with valid TCP/IP connection. Select the network on which the MC and your workstation
will communicate from this list.
Enable Discovery Network Wide Logging Toggle this setting on for debugging only.
Display Discovery Database Opens a list of all EUCON clients on the network.
Quit Shuts down the MC Client service.
IP Addressing
MC
The Netgear RP614 router (or other) included with the standalone MC takes care of all IP addressing, using its internal DHCP
server to distribute IP addresses to the MC and your workstations. Make sure the router is powered on and connected (with Ether-
net cables) to your MC and workstations for the DHCP server to correctly assign IP addresses.
The WAN port on the Netgear can be connected to a studio LAN, or to an Internet connection, depending on your studio setup.
Note that the MC and workstations must be on the same network subnet for the MC to connect to your workstations properly
(connecting them all to the LAN ports on the Netgear automatically does this).
Euphonix Control Panel