User guide

Avid Mbox Pro User Guide36
Link
The Link buttons connect stereo pairs of knobs or
faders (and also links the corresponding FX Send
knobs), so that adjusting either channel (left/right)
adjusts the other side identically.
Hardware Input FX Sends
FX Sends are shared by all Stereo Mixes, unless
“Post-Fader Stereo Mix 1” is chosen in the Setup
pop-up menu.
Software Return FX Sends
FX Sends are shared by all Stereo Mixes, unless
“Post-Fader Stereo Mix 1” is chosen in the Setup
pop-up menu.
FX Returns
These knobs control how much of the Effect audio
output will be mixed in with the monitor signal
Master L/R outputs. Unlike sends, FX Returns are
individually adjustable for each stereo mix.
The Clip LED will show clipping if the input to the
FX is clipping and if the output is clipping (the rest
of the meter is just output).
Effect
The Effect drop-down menu is used to select the
effect to be applied to the Hardware Inputs and/or
Software Returns (effects are not available if the
sample rate is > 96 kHz). There are five available
reverb types: Three room reverbs and two hall re-
verbs, delay, and echo. These effects can be cus-
tomized by using the following three controls:
Duration This knob controls decay time (for the re-
verbs) or delay time (for delay and echo).
Feedback This knob controls the number of re-
peats for the delay and echo effects. It does not af-
fect the reverbs.
Volume This knob controls the effects output level
being sent to the FX Returns
Pan controls are unaffected by linking two
channels.
Links buttons
FX Returns (below Master section)
Master section
FX Returns section