User guide

Mbox User Guide32
Monitor Outputs (1–2, 3–4, 5–6)
Name
You can name your stereo Monitor output pairs
by clicking in the box. The name appears in the
Output Pair tabs in the Stereo Mix section. See
“Output Pairs” on page 36.
Control Room Assignment
This drop-down menu assigns a Monitor output
pair (1–2, 3–4, 5–6) as a control room output.
Choose between the following options:
•None
• Speakers A (Green LED)
• Speakers B (Red LED)
•Speakers C (Amber LED)
Let’s say that outputs 1–2 are set up to be Speak-
ers A, outputs 3–4 are set up to be Speakers B,
and outputs 5–6 are set up to be Speakers C.
Pressing Mbox Pro’s Speaker button lets you
switch between the three pairs of speakers.
(Only one control room output pair is active at
any time in Stereo mode.)
Master Vol.
This option lets you choose which output pairs
are controlled by Mbox Pro’s Master Volume
knob.
If you enable this option for the all three Moni-
tor output pairs, then the Master Volume knob
controls all of them at once.
Left Trim This knob trims the level of the Left
(odd numbered) output.
Right Trim This knob trims the level of the Right
(even numbered) output.
S/PDIF Outputs L/R
These outputs are not assignable as control
room outputs. You can assign a name to your
stereo output pairs. The name appears in the
Output Pair tabs in the Stereo Mix section.
Headphone Outputs A and B
These outputs are not assignable as control
room outputs. You can assign a name to your
stereo output pairs. The name appears in the
Output Pair tabs in the Stereo Mix section.
If an output pair is designated as a control
room speaker pair, this checkbox is auto-
matically checked and cannot be un-
checked.