Product specifications

Customize the Uplink on the Dell Networking Switch
72
5. hostname(config-if-vlan10)# exit
6. hostname(config)# exit
7. hostname# write
Setting Up IP-Helper Addresses for DHCP (Other Dell Networking Switches)
To use DHCP on the clients that are connected to the Avid Production switch you must add an IP Helper Address
to each VLAN. The IP Helper Address points the hosts to the DHCP Server that is on the house network.
To add an IP Helper Address:
1. Use your terminal emulation or telnet into switch.
2. Type
en .
3. You are prompted for a password, type
avid .
4. Type
conf .
5. Type
int vlan n (where n is the VLAN)
6. Type
ip helper-address xxx.xxx.xxx.xxx (where x's equals the IP address of the DHCP server)
7. Type
exit
8. Type exit .
9. Type
wr mem .
10. Type
Yes .
Upgrading FTOS
n
This procedure does not apply to the N3024 switch. For information on upgrading the firmware on the N3024, see
the documentation for the switch.
To upgrade the ftos (Dell Networking operating system):
1. Type en .
2. Type
upgrade system tftp://tftp_server_ip_address/ftos_file_name
3. Type Reload .
4. Type
Yes .
Upgrading U-Boot
n
This procedure does not apply to the N3024 switch. For information on upgrading the firmware on the N3024, see
the documentation for the switch.
To upgrade the u-boot (universal bootloader):
1. Type en .
2. Type
upgrade boot tftp://tftp_server_ip_address/u-boot_file_name
3. Type Reload .
4. Type
Yes .