Product specifications

Customize the Uplink on the Dell Networking Switch

Rate info (interval 299 seconds):

Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Output 00.00 Mbits/sec, 1 packets/sec, 0.00% of line-rate

Customize the Uplink on the Dell Networking Switch

This section describes how to customize the Dell Networking switch configuration to uplink to your house

network. The procedure in this section assumes the following:

• The System Director has been setup and the Avid ISIS software has been installed.

• The Dell Networking switch is currently running with the “avid-default” configuration loaded and has not

been modified.

• The Avid ISIS is connected to the Dell Networking switch using either the 1 Gb or 10 Gb connection.

• The IP Address on the ISIS | 5500 Engine is configured with the default values (192.168.255.11, 13, 14, 16

for 1 Gb or 192.168.255.21 for 10 Gb)

You might need to change the IP address on the ISIS | 5500 Engines and clients when customizing your uplink in

these procedures.

Network Setup Requirements

You need to obtain following information from your corporate Information Technology (IT) department before

you customize your Dell Networking uplink:

• Uplink IP address for Vlan or Port IP address/subnet mask ______.______.______.______ /_____ (slash

notation for subnet mask)

• Vlan IP address for local subnet ______.______.______.______ /_____ (slash notation for subnet mask)

• Switch's default gateway Address ______.______.______.______

• (Optional) DHCP server (ip helper addresses)

- First: ______.______.______.______

- Second: ______.______.______.______

• Static IP addresses for each Avid ISIS Engine; four IP addresses for the 1 Gb connections, one IP addresses

per Engine for the 10 Gb connections)

• Port on a corporate network switch to connect the Dell Networking switch

Configure an Uplink Port on the Dell Networking N3024/N3048

After you have obtained the information previously listed for from your corporate administrator, configure the

Dell Networking switch as using the following procedure.

To copy the Avid configuration file from flash memory in the switch:

1. hostname#

configure

2. hostname(config)#

interface gigabitethernet 1/0/24

3. hostname(config-if-gig1/0/24)#

switchport mode trunk

4. hostname(config-if-gig1/0/24)#

ip address 192.168.10.1 255.255.255.0