Product specifications
Restoring the Avid Dell Networking Configuration
63
13. Manually reapply any switch changes you might have applied during your initial switch setup
Turning on Flow Control in the Dell Networking N3024/N3048 Switch
The Dell Networking N3024 or N3048 switch configuration has Flow Control turned on by default. Flow Control
is needed to support ISIS | 5500 10 Gb clients.
If you suspect or know that Flow Control has been disabled, use the following procedure enable it again.
To turn on Flow Control:
1. Use your terminal emulation or telnet into switch.
2. hostname#
configure
3. hostname(config)#
flow control receive on
4. hostname(config)#
exit
5. hostname#
write
Turning on Flow Control in the Dell Networking S25 Switch
The Avid default Dell Networking S25N and S25P (fiber) switch configurations do not have Flow Control turned
on. Flow Control is needed to support ISIS | 5500 10 Gb clients. Use the following procedure to turn on Flow
Control in the Dell Networking switch.
n
Avid is turning rx and tx
on
in the Forece10 S25 switch, but the Forec10 S60 and S4810 switches have rx
on
with
tx
off
in the Avid default configuration.
To turn on Flow Control:
1. Use your terminal emulation or telnet into switch.
2. Type
en
.
3. You are prompted for a password, type
avid
.
4. Type
conf
.
5. Type
Int range tengigabitethernet 0/25 - 28
.
Depending on your Dell Networking S25 switch module options, use one of the following command in place
of this step.
t Left 10 Gb module installed (numbered right to left, facing rear)
Int range tengigabitethernet
0/27 - 28
.
t Right 10 Gb module installed (numbered right to left, facing rear)
Int range tengigabitethernet
0/25 - 26
.
t Right stacking module installed (numbered right to left, facing rear)
Int range tengigabitethernet
1/25 - 26
.
6. Type
flowcontrol rx on tx on threshold 1024 1024 1054
.
n
The following steps turn the port off and back on to enable the change. Make sure this isn't an interface from
which you are gaining remote access because you will be disconnected.
7. Type
shut
.
8. Type
no shut
.