Product specifications
Restoring the Avid Dell Networking Configuration
62
Restoring From the Avid Software Kit
This section describes how to restore the Avid default Dell Networking switch configuration to your switch from
the ftp folder on your ISIS | 5500 System Director. The procedure in this section assumes the following:
• The System Director has been set up and the Avid ISIS software has been installed.
• The switch is connected to the ISIS environment.
• The IP Address on the ISIS | 5500 Engines are configured with the default values (192.168.255.11, 13, 14, 16
for 1 Gb or 192.168.255.21 for 10 Gb)
n
The Avid default configuration files (avid-default) are also located on the Avid ISIS software installer kit
[drive]:\Switch Configuration\ISIS 5000\Dell Networking\. The configuration files are text files that can be viewed
using an application such as WordPad. You should upgrade your switch to the latest configuration file found in the
ISIS software kit.
To copy the Avid configuration file from the Avid software kit to the switch:
1. On System Director copy the Avid supplied Dell Networking configuration file (replace switch folder in the
following path with the appropriate switch model):
From — [Avid software kit]:
\Switch Configuration\ISIS 5000\Dell Networking\
switch folder
To —
C:\Program Files (x86)\Common Files\Avid ISIS Shared\ftp\
2. From the System Director, use your terminal emulation or telnet into switch.
3. Type
en
.
4. You are prompted for a password, type
avid
.
5. Copy the new configuration:
t For 1 Gb type “
copy ftp://administrator:is-admin@192.168.254.11/
avid-default startup-config
”
t For 10 Gb type “
copy ftp://administrator:is-admin@192.168.254.21/
avid-default startup-config
”
When asked to confirm the file copy type
yes
and press Enter.
If the copy is successful, you see the following:
(number of “!” and bytes copied could vary slightly)
!!
2831 bytes successfully copied
6. Type
Reload
.
7. You are sometimes prompted to save, type
No
.
8. When asked to reload, type
Yes
.
n
When you perform a reload the Dell Networking S25 switch restarts, you see a Disconnected message, and have to
log back in before continuing.
9. (Dell Networking S25 only) Type
en
.
10. (Dell Networking S25 only) Type
Wr mem
.
11. (Dell Networking S25 only) Type
Reload
.
12. (Dell Networking S25 only) Type
Yes
.