Product specifications
Qualified and Approved ISIS Switches
18
Switch Vendor Commands
The following table provides a few command similarities and differences between vendors.
Sample Switch Configurations
Avid includes switch configuration files outlined in “Sample Switch Topologies” on page 93. You can load and
modify one of the configurations provided in the software kit to create a switch configuration file compatible with
your environment. These configurations can be applied using the procedures outlined in this document or by
vendor. Some configuration files provided in the ISIS software kit have a provision for one port to connect to the
house network for Zone 4 support.
The following table provides information on the available ports and connections.
Cisco GLBP
Switch 1
ip address 192.168.10.2 255.255.255.0
glbp 110 ip 192.168.10.4
glbp 110 preempt
ip address 192.168.20.2 255.255.255.0
glbp 120 ip 192.168.20.4
glbp 120 priority 90
Cisco GLBP
Switch 2
ip address 192.168.10.3 255.255.255.0
glbp 110 ip 192.168.10.4
glbp 110 priority 90
ip address 192.168.20.3 255.255.255.0
glbp 120 ip 192.168.20.4
glbp 120 preempt
Foundry/Brocade VRRPE
a
Switch 1
ip address 192.168.10.2 255.255.255.0
ip vrrp-extended vrid 10
backup priority 120
advertise backup ip-address 192.168.10.4
ip address 192.168.20.2 255.255.255.0
ip vrrp-extended vrid 20
backup priority 110
advertise backup ip-address 192.168.20.4
Foundry/Brocade VRRPE
Switch 2
ip address 192.168.10.3 255.255.255.0
ip vrrp-extended vrid 10
backup priority 110
advertise backup ip-address 192.168.10.4
ip address 192.168.20.3 255.255.255.0
ip vrrp-extended vrid 20
backup priority 120
advertise backup ip-address 192.168.20.4
a. Foundry/Brocade VRRPE must also specify the following Global Configuration: router vrrp-extended.
Command VLAN 10 VLAN 20
Command Dell Networking Cisco Foundry/Brocade
Entering Enable Mode en en en
Entering Global Config
Mode
conf conf t conf t
Enabling IP Routing ip routing ip routing Automatic if more than one router
interface is defined
Changing IP addresses New IP address automatically
replaces old
New IP address automatically
replaces old
You must remove the old IP address
first using the “no ip address”
command