Product specifications

Qualified and Approved ISIS Switches
17
Default Switch Passwords
The following default passwords allow you to access the enable mode on the switches.
Redundant Switch Configurations
The following table provides redundant switch configuration examples by ISIS VLAN.
Dell Networking S60 FTOS 8.3.3.4 (and later
a
) 48 1 Gb (RJ-45),
two slots for modules, two 10 Gb SFP+ ports
per module (SFP+/LC)
Dell Networking S4810 FTOS 8.3.7.0 (and later
a
) 48 dual-speed 1/10 Gb (SFP+)
(four 40 Gb QSFP+ uplinks, not supported in
the Avid Environment)
a. Later firmware/IOS version should be acceptable but are not tested by Avid.
Minimum Supported Switch Firmware and IOS Versions (Continued)
Manufacturer Model Firmware/IOS
a
Description and
Approved Blades
Manufacturer Model Password Comment
Cisco 4900M
4948E;
4948-10GE
Not Set by Default To get into enable mode in a Telnet session, create an
enable password on the serial connection in Global
Configure Mode by using the “Enable Secret”
command.
Dell Networking N3024
N3048
User: avid
Password: avid1234
The N3024 and N3048 switches are supported only
with ISIS | 5500 and ISIS | 2500 environments.
Dell Networking S25
S60
S4810
User: avid
Password: avid
The S25 switch is supported only with ISIS | 5500 and
ISIS | 2500 environments.
The S4810 switch is supported only with ISIS | 7500 in
dual Management Domains in an External Switch
configuration.
Foundry/Brocade FESX624
FESX424
Not Set by Default Press Enter to access enable mode.
Command VLAN 10 VLAN 20
Cisco HSRP
Switch 1
ip address 192.168.10.2 255.255.255.0
standby ip 192.168.10.4
standby priority 95
standby preempt
ip address 192.168.20.2 255.255.255.0
standby ip 192.168.20.4
standby priority 90
Cisco HSRP
Switch 2
ip address 192.168.10.3 255.255.255.0
standby ip 192.168.10.4
standby priority 90
ip address 192.168.20.3 255.255.255.0
standby ip 192.168.20.4
standby priority 95
standby preempt