Specifications

Chapter 4: Configuring Your Pro Tools System 35
6 When prompted, power cycle all Pro Tools pe-
ripherals in your system. Click Continue.
7 To test the interfaces connected to your sys-
tem, check “Test I/O Box.”
8 When the test is finished, you can view the
test results by doing one of the following:
• Click the Get Results button next to a card
name.
• Click the Results tab and choose a card slot
from the pop-up menu.
9 In the Results page of the DigiTest window,
click Show Failures Only to display failed tests
for the selected card, or click Show All Results to
display all test results for the selected card.
10 Click Quit to close DigiTest.
11 Restart your computer.
Errors and Undetected Cards
Complete the steps below if any of the following
occur:
 DigiTest fails to launch.
 An error message has been displayed for a card
in DigiTest.
 A supported card is installed but not automat-
ically detected during DigiTest.
If a supported card is installed and is not
automatically detected:
1 Quit DigiTest.
2 Turn off the entire Pro Tools system.
3 Reinstall the Pro Tools|HD cards.
4 Check the card seating.
5 Check the TDM FlexCable connections.
Check the orientation of the cable from card to
card (ports B to A), and check the integrity of the
FlexCable connections to the cards.
6 Turn on the system.
7 Run DigiTest again.
DigiTest Error Codes
LEDs on your digital interfaces may light up
during this test. This is normal.
For descriptions of error codes, refer to “Dig-
iTest Error Codes” on page 35
DigiTest Error Codes
Code Description
Err3 Cards from different Pro Tools
systems are incorrectly mixed.
See the configuration chapters.
Err4 Cards marked with this error are
installed in the wrong order. See
the configuration chapters.
Err5 Too many cards of this type are
installed in the system. Refer to
the Digidesign website for com-
patibility information.
Err6 A card is installed in a reserve
slot. For example, a Digidesign
card is installed in the slot
reserved for the Expansion Chas-
sis Host Interface card. Refer to
the configuration chapters, as
well as related installation guides.
Err1220 SCSI Accelerator card is installed
in the wrong slot. See the configu-
ration chapters for correct loca-
tion of the card.
Err1221 Expansion Chassis Host Interface
card is installed in the wrong slot.
See Expanded Systems Guide for
correct location of the card.