Installation manual

TECHNICAL SERVICE

Carefully stretch the overdrive spring around into the grooves

of the collar plate and each of the pawls.

NOTE:

Be careful not to damage the spring upon removal by over

stretching or kinking it. If the spring is damaged upon installation,

replace it with a new one.

Make sure that the spring is fully seated in the groove of the collar

plate and the pawls.

Collar Seal Reassembly

Pull the actuator arm so the pawls are retracted, and re-install

the collar seal, lip side down. Make sure it is fully seated and

check again that the pawls can extend and retract without

interference.

Chain Guide Reassembly

If the chain guide was removed due to damage, install a new

chain guide onto the collar plate in the same location as before

the service. Using a 2.5 mm hex wrench, install the two chain

guide screws. Torque to 0.7 N·m (6 in-lb).

R E A S S E M B L E T H E C O L L A R P L A T E

ASSEMBLY

For reassembly of the collar plate assembly follow the instructions

as shown under headings “Collar Plate Assembly Installation” in

the Installation section of this manual.

For installation of the shifter cable and shifter adjustment follow the

instructions as shown under headings “HammerSchmidt Shifter

Installation” in the Installation section of this manual.

SAFETY CHECK

WARNING:

Before setting out on a ride, perform a parking lot test to

ensure the HammerSchmidt shifts and functions properly.

This concludes the Collar Plate Assembly Service for

your HammerSchmidt. You did a great job!