Installation manual

TECHNICAL SERVICE

Using a 2 mm hex wrench, install the seal disk bolt. Torque to

0.6 N·m (5.0 in-lb).

Cable Anchor Bolt Reassembly

Using a 4 mm hex wrench, install the cable anchor bolt and

washer. Tighten to hand-tight.

Overdrive Pawls Reassembly

Apply a light coat of grease to pawl seats on the collar plate

assembly.

Install the pawls in the collar plate assembly. Make sure the

pawls are oriented correctly. The round end should be seated

in the pocket and the square end should be exposed.