Installation manual

TECHNICAL SERVICE

CLEAN COLLAR PLATE ASSEMBLY

Thoroughly clean any contamination and grease from the components of the collar plate assembly. Ensure that any grease residue

is removed from the pawls, pawl seats, actuator, and the actuator recess in the collar plate and ensure these components are dry

prior to applying fresh grease.

GREASE AND REASSEMBLE COLLAR PLATE

IMPORTANT:

Use only the grease provided in the HammerSchmidt grease kit inside the collar plate assembly. Poor performance and

accelerated wear can be expected from use of other lubricants.

Crank Stop Reassembly

Insert the crank stop and secure it in place with the crank stop

retainer. Make sure that the retaining ring is fully seated in the

groove of the crank stop.

Actuator Reassembly

Apply a light coat of grease over the entire actuator, evenly

distributing it with a small grease brush or your ﬁnger. Apply a

light coat of grease to the corresponding recess in the collar

plate.